This study evaluates the effectiveness of remote human-robot interaction using virtual reality for leaf inspection and soil moisture assessment in a greenhouse environment. The robotic system comprised an unmanned ground vehicle and a robotic manipula
This study evaluates the effectiveness of remote human-robot interaction using virtual reality for leaf inspection and soil moisture assessment in a greenhouse environment. The robotic system comprised an unmanned ground vehicle and a robotic manipulator equipped with cameras, governed by kinematic models for navigation and manipulator control. Fourteen distinct plants were inspected across two experiments utilizing VR teleoperation, guided by a set of pre-specified research questions and hypotheses. In the leaf inspection experiments, cycle completion times varied from 3.3 to 8.0 s, and plant-based disease detection was achieved up to 88% accuracy; diseased-spot detection improved numerically in the second experiment, though this change was not statistically significant (p=0.378). For soil moisture assessment, the experiments achieved successful determination of watering needs in up to 64.3% of plants (9 of 14), with consistent success observed for plants 1, 2, 3, 8, 9, 10, and 13; however, this improvement was likewise not statistically significant (p=0.50). A post hoc analysis instead revealed that soil moisture assessment reliability was strongly and significantly predicted by plant canopy morphology (p<0.01): plants with broad, single-leaf canopies reached 100% success by the second experiment, versus only 16.7% for dense, compound canopies. A secondary analysis showed operators became measurably faster at attempting dense-canopy plants without a corresponding gain in success, indicating that camera occlusion, not operator skill or effort, is the dominant limiting factor. These findings show occlusion imposes a sensing limitation rather than a control or training deficiency, and that adapting camera viewpoint and sensing strategy to canopy density is needed to improve the system's accuracy and robustness.